Coolmax power supply manual

The PG "time" is an indication of how fast the power supply reaches its proper voltages at turn-on. Faster is better. "PWR_OK is a "Power Good (PG)" signal. When power supply is turned on, AFTER the power supply sees that the primary voltages (+12 VDC, +5VDC, and +VDC) are above the under-voltage thresholds, it changes PWR_OK from zero to +5V/5().  · The reviewed power supply doesn’t have an active PFC circuit, has a manual V/ V switch, and is based on the obsolete half-bridge design. The Coolmax V is ” ( mm) deep, using a Estimated Reading Time: 8 mins. Before we take a closer look at the CoolMax CUQB W ATX/EPS 12V power supply, let's check its Features and Specifications taken from the box, manual and CoolMax's web site. Features: Hairline Aluminum Effect Surface; Quad +12V output rails; Advanced double forward circuit and double-layer PCB; Active power factor correction.

The COOLMAX GREEN POWER CUQB is a mammoth W ATX power supply, retail for $ CDN ($ US, £ GBP). In the +W class power supplies are priced at a premium, so let's see if the CUQB is worth it. The COOLMAX GREEN POWER CUQB is a massive power supply measuring 22 x x cm. Manual: Plug-in your ATX power 24 pin and plug-in (P4/P6/P8) into the tester. Turn on your ATX power supply; LCD shows each voltage and P.G. value on the screen automatic and you can hear 2 beep sounds. ATX power output connector checking one by one. If power output is working, the LED will light on. The PS will test the standard or pin motherboard power supply. A n LCD screen displays the test results, and you don't have to look up codes in a manual, like you do with cheaper models. The tester is accurate within +/- V, and it'll set off an alarm if the voltage is too low, too high, or just not working.

The reviewed power supply doesn’t have an active PFC circuit, has a manual V/ V switch, and is based on the obsolete half-bridge design. The Coolmax V is ” ( mm) deep, using a. The I power supplies are durable, practical, and efficient. Remove all superfluous attachments and features. The I can provide reliability and watts of power you can depend on to run your system. The PG "time" is an indication of how fast the power supply reaches its proper voltages at turn-on. Faster is better. "PWR_OK is a "Power Good (PG)" signal. When power supply is turned on, AFTER the power supply sees that the primary voltages (+12 VDC, +5VDC, and +VDC) are above the under-voltage thresholds, it changes PWR_OK from zero to +5V.