Cyrus 6 DAC, Cyrus 8 2 DAC User Instructions 2 Power supply Connect the moulded IEC connector of the AC cord supplied plugs into the power inlet 2) on the rear of the unit. The mains supply requirement of your amplifier is marked on a label on the rear panel. Before connecting, check that this voltage is the same as your mains supply. These user instructions refer to the Cyrus 6 Power, Cyrus 8 Power and Cyrus X Power amplifiers. Model differences are indicated in the text where they occur. Preparations for Installation Before installing the Cyrus 6/8/X Power check that the following items are included in the accessory box. • Guarantee Card (back page of instruction manual. For more details on the PSX-R, please refer to the Cyrus PSX-R Instruction Manual. INSTALLATION Cyrus Power Amplifier English 6 STEREO AND DUAL MBLOC MODES The Cyrus Power can be configured as either a stereo 50W per channel amplifier or as a single channel W Mbloc mono amplifier. In Mbloc mode not only is there.
Cyrus one is a great amplifier, I am using it since I don't want to upgrade for a bit better amplifier. The Cyrus one produce 3 dimensional sound. some time I have to look around to find that unique sound but it is coming from the speaker. I was trick many time. Living with a brand-new Cyrus amp was a pleasantly nostalgic thing to do, even from the start: It arrived in a clean and downright attractive carton that seemed designed specifically to contain a brand-new Cyrus amplifier. Think of it! And I haven't even mentioned the nice owner's manual or the balance control or the headphone jack. As I said: the good old days. Finish: silver / satin black. Power output: 70 watts per channel into 8Ω (stereo) Frequency response: Hz to 85kHz. Total harmonic distortion: %. Damping factor: Input sensitivity: mV (line) Signal to noise ratio: dB (line) Output: mV (line), V (Pre out) Dimensions: 73 x x mm.
Cyrus one is a great amplifier, I am using it since I don't want to upgrade for a bit better amplifier. The Cyrus one produce 3 dimensional sound. some time I have to look around to find that unique sound but it is coming from the speaker. I was trick many time. Cyrus 6 DAC, Cyrus 8 2 DAC User Instructions 2 Power supply Connect the moulded IEC connector of the AC cord supplied plugs into the power inlet 2) on the rear of the unit. The mains supply requirement of your amplifier is marked. Manual Library / Cyrus. Cyrus 6. Remote Control Line Level Integrated Amplifier. add a review. Specifications. 6; 6VS; 6VS2; Power output: 40 watts per channel into.
0コメント